How to Assemble Your GNP Defend Floor Display
The full-size floor display that ships with your dealer order goes together in a few minutes with no tools: the base folds into a box, the back panel and shelves are tab-into-slot, and the printed front slides on. Watch it once, then follow the steps below.
- Lay the parts out on the floor in the order you will use them: base panels, camo back panel, printed front, four shelves.
- Fold the large base panels up and tab them into each other until they form a closed box, pressing each tab home.
- Lift the camo back panel onto the base box with the logo at the top, seat it, and stand it upright, pressing the tabs home at both sides.
- Slide the printed THE BEST SHOT front sleeve down over the base until it sits flat against the box.
- Slot the four shelves into the back panel, one per pair of slots, in any order; the tabs only fit one way.
- Step back and check that every joint sits flush, then set the stand on a flat floor against a wall.
In the box: the large base panels that fold into the box, the tall camo back panel with the round GNP logo topper, the printed THE BEST SHOT front sleeve, and four shelves. Nothing else is needed: no screws, no glue, no tools. Every joint is a tab into a slot and the front sleeve slides down over the base, so if a piece will not go, check that the tab is lined up with the slot rather than forcing it. The shelves fit in any order; the tabs only go one way. Set the stand on a flat floor against a wall, and load the shelves from the bottom up so it stays steady. Wipe with a dry cloth only; keep sprays and oils off the print. If a piece is missing or damaged, email Info@GNPDefend.com or call 1-800-385-4889 and we will send a replacement.