How to Assemble Your GNP Defend Countertop Display
The flat-pack countertop display that ships with your first dealer order goes together in a few minutes with no tools: every panel is tab-into-slot. Watch it once, then follow the steps below.
- Stand the camo back panel up with the logo topper at the top and the slots facing you.
- Slide one side panel onto the back panel, tab into slot, then the other, until both sit flush.
- Slide the upper shelf in from the front so its tabs seat in the side slots, then the lower shelf beneath it.
- Press the camo front lip onto the front edge of the base so it locks the shelves in place.
- Turn the stand around and press every tab home from the back until each joint sits flush, then set it upright.
- Clip the two acrylic GNP sign holders onto the front corners and press the logo topper down until it seats.
In the box: the camo back panel with the round GNP logo topper, two side panels, two stepped shelves, the camo front lip, and two acrylic GNP sign holders with their clips. Nothing else is needed: no screws, no glue, no tools. Every joint is a tab into a slot, so if a piece will not go, check that the tab is lined up with the slot rather than forcing it. The sign holders clip onto the two front corners of the base and hold the printed shelf cards. Wipe the stand with a dry cloth only; keep sprays and oils off the print. If a piece is missing or damaged, email Info@GNPDefend.com or call 1-800-385-4889 and we will send a replacement.